FirstCoastCobraClub

Tom,

What speed level did you sign up for?

Will do Tom

Haven’t taken it out yet, but noticed a small puddle of antifreeze under the front of the motor as I was finishing up a few small things yesterday… :roll:

Guessing it was from running it last week and heat soaking at high idle… :think:

If I can’t spot the leak from above, I may have to reconnect ...

Phil and I are heading to Daytona Friday morning for HSR qualifying and walking the pit areas. Leaving my house around 8:00 AM if you’re interested in joining us…

Thx Ken…no, nothing formal, I’ll just run it at different speeds/RPMs, monitor gauges, listen for any unusual noises, make mental notes of anything I’ll need to look into. Any suggestions for a more formal rundown?

I’ve spent quite a bit of time sorting out the front suspension, and I think I have it at a pretty good point. Lots of up and down, tires on and off, make changes, recheck alignment, etc…

I won’t bore you with nitty gritty details, end result is as follows:

Camber:
LF 3/4 degree negative
RF 5/8 ...

Brace yourselves, here comes another one…

Still chipping away at the old rock pile… :whistle:

Received the new Moog LbJ today and got to work removing the old one…well, old in the sense that it’s been on the car a lot of years, but certainly not worn out other than the two piece grease boot. :roll:

I had to modify the bj remover some ...

IDK Ken, a little krazy glue and you’re back in business…

Btw, this is the system I devised to prevent them from being knocked to the ground. I’ll heed your warning and add some wire mesh protection as well…